SPONSORS
2024 ICRBE EXPO |
Integrated Carbon Fiber Spinning Handle Butt Cap
Posted by:
Bill Falconer
(207.203.39.---)
Date: April 26, 2013 02:15PM Another photo of an integrated one piece handle butt section - this one uses an EVA butt cap. Thanks to Capt. Mike Pedersen for the inspiration and instruction. If you measure / set up carefully and use the hose clamps from Riley Rods, it is very easy to get square edges and clean fit / finish on butt caps and trim rings. Much more to follow... Sorry, only registered users may post in this forum.
|