SPONSORS
2024 ICRBE EXPO |
Learning on the lathe
Posted by:
Raymond_Adams
(72.22.232.---)
Date: December 26, 2007 12:28AM Been at Dad's in Idaho on holiday and he's been teaching me on his lathe. Lower rod is my first turned set of handle reel seat & forgrip nub. Turned from the same piece of cedar. Upper set is a carved reel seat and matching butt cap I was lucky enough to aquire from Paul Kneller from Australia (THANKS PAUL!)and grips from rings I glued & turned. LATHES ARE COOL!!!!!! Done some shapping on my power wrapper but the lathe beats that hands down!! Sorry, only registered users may post in this forum.
|