SPONSORS
2024 ICRBE EXPO |
The good and the bad
Posted by:
Wylie Wiggins
(64.136.26.---)
Date: June 01, 2006 12:40AM These are the newest addition to my shop. I made the stand for the molds and thought the whole contraption looked pretty cool so I'm posting it. These are molds that I can use to cast end caps machined by some of the best avionics machinists in the world. The case is another failed attempt at a vacuum chamber to illiminate the bubbles through the interior of the finished castings. I'm doing this so the finished parts can be turned down on a lathe. I think all that needs to be done is a bead of silicone on the interior edge of the blank ring on the lid side and I've aced the vacuum chamber. Attempt#? :( Sorry, only registered users may post in this forum.
|