SPONSORS
2024 ICRBE EXPO |
A tool I made for pistol grip handle to mount in the dryer or wrapping lath
Posted by:
Lynn Williams
(76.177.161.---)
Date: July 31, 2007 11:13AM I cut a 1†PVC pipe about 7†long then cut two ½†fingers about3 ½ long 180 degrees from each other then put a little duct tape on the fingers to protect the handle. I also put piece of cork in the end of the pipe so it will mount easier in the dryer or lathe. Sorry, only registered users may post in this forum.
|