SPONSORS
2024 ICRBE EXPO |
need guide spacing for Payne 97 bamboo
Posted by:
Sam Slack
(---.inf6.spectrum.com)
Date: September 17, 2020 10:47AM
Building lst bamboo flyrod with Payne 97 taper. Does anyone have some suggestions for guide size and spacing of the Payne 97 taper? Re: need guide spacing for Payne 97 bamboo
Posted by:
Donald La Mar
(---)
Date: September 19, 2020 07:11PM
Go here [www.rodcents.org] , enter line weight and length, and use the results for the starting positions. Then static load test, adjust positions, load test again, etc.
The initial results from the calculator will probably not be correct, but ir will get you close enough to begin load testing. Sorry, only registered users may post in this forum.
|