SPONSORS
2024 ICRBE EXPO |
rodgeeks blank dimensions
Posted by:
ethan johnson
(---.cpe.echoes.net)
Date: April 07, 2020 06:10PM
is there a resource for rodgeeks blank dimensions for winding checks and such , similar to the one mudhole has for the mhx blanks? if not is there any one that could get me the measurements on a C4F907.4 fly blank please . measurements at 3,7,14 " thank you ethan johnson Re: rodgeeks blank dimensions
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: April 07, 2020 06:39PM
To the best of my knowledge MHX is the only blank to provide this info, and it is indeed a great service to builders. Others should take note. Re: rodgeeks blank dimensions
Posted by:
Billy Vivona
(---.nycmny.fios.verizon.net)
Date: April 07, 2020 07:04PM Re: rodgeeks blank dimensions
Posted by:
ethan johnson
(---.cpe.echoes.net)
Date: April 08, 2020 07:46PM
hmm well aint that sumthin.. apparently they do have that list thank you billy . unfourtunately they dont do the list for the carbon 4 fly blanks. am i to assume that they are just one steady ( or close to it ) taper ? Re: rodgeeks blank dimensions
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: April 08, 2020 07:52PM
You know what happens when you assume ! LOL High probability they are not a steady taper, much depends upon the blanks action. Re: rodgeeks blank dimensions
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: April 08, 2020 08:00PM
Thanks Billy, great to hear this. Re: rodgeeks blank dimensions
Posted by:
ethan johnson
(---.cpe.echoes.net)
Date: April 08, 2020 10:38PM
totally agree with the assuming part lol, but i do think its strankge they have measurements for all thier blanks except the fly blanks
thanks guys A word you have used in your post has been banned from use. Please use a different word or contact the forum administrators.
Sorry, only registered users may post in this forum.
|