SPONSORS
2024 ICRBE EXPO |
Citristrip to clean off old paint
Posted by:
Dennis Herold
(---.dsl.atmc.net)
Date: October 11, 2019 01:15PM
Want to remove original paint off of some E-Glass blanks and got some feedback to use Citristrip.My concern is that it said on directions on bottle not to use on vinyl, plastic and fiberglass . Will this product hurt the E-Glass blanks?Thanks Dennis Re: Citristrip to clean off old paint
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: October 11, 2019 02:28PM
I have used it on ugly stix and other fiberglas blanks with no ill effects. Don't know about E-glass however. Re: Citristrip to clean off old paint
Posted by:
Dennis Herold
(---.dsl.atmc.net)
Date: October 11, 2019 02:55PM
Thanks Lynn I have some older Gator blanks never been used but just don't clean up nice enough for me this is why I want to try this route. Re: Citristrip to clean off old paint
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: October 11, 2019 04:30PM
I always put it on and let it sit overnight then scotchbrite it off under running water. It often takes more than one application. You could apply it, let it sit for a few hours then scotchbrite it and see how far it gets you. It's a messy process best done outside or at a utility sink. That's not to say I haven't done it in the kitchen. (best done when home alone!) Re: Citristrip to clean off old paint
Posted by:
Dennis Herold
(---.dsl.atmc.net)
Date: October 11, 2019 04:54PM
Thanks Lynn for your help.Headed up to NJ for a week then coming back to NC and will tackle a blank and give you a heads up. Once again Thanks Re: Citristrip to clean off old paint
Posted by:
Mark Talmo
(---)
Date: October 12, 2019 04:09PM
Dennis,
I used CitriStrip on two rods when I first started building rods. Lynn is correct in that it is a rather mild stripper and will probably require 2 or 3 applications and that it certainly is messy. I have found scraping the blank with a razorblade held 90* to the blank to be much easier, less time-consuming (30 minutes max), no mess and no cost for the stripper. I learned of the method on this site and so there will be others who agree. Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Sorry, only registered users may post in this forum.
|