SPONSORS
2024 ICRBE EXPO |
Cork Handle Engraving
Posted by:
Brandon Smith
(---.midco.net)
Date: April 28, 2019 03:22PM
Hi All,
I recently purchased a laser engraver to engrave cork handle. Im wondering if a person can or should put some kind of clear coat over it help protect and preserve the engraving. Any thoughts, comments, or tips are appreciate. Re: Cork Handle Engraving
Posted by:
John DeMartini
(---.res.spectrum.com)
Date: April 28, 2019 06:34PM
Brandon
When you finish I suggest you apply any good cork seal product and always clean or wipe down the cork after use. John Re: Cork Handle Engraving
Posted by:
Mike Laver
(---.home4.cgocable.net)
Date: April 29, 2019 08:11AM
So which laser engraver did you get, and any pictures of the results? Re: Cork Handle Engraving
Posted by:
Brandon Smith
(---.midco.net)
Date: April 29, 2019 09:33PM
Mike the laser is a Welquic. Its been good so far. Wish you can do a little more with the software but it does the trick. Im not sure how to put pictures on here. Re: Cork Handle Engraving
Posted by:
Mike Laver
(---.home4.cgocable.net)
Date: April 30, 2019 12:17PM
I'm guessing the software is a basic CAM program, a graphic software program would give better files to export to the laser's software. Re: Cork Handle Engraving
Posted by:
Claude Iler
(---.lightspeed.gnvlsc.sbcglobal.net)
Date: May 17, 2019 10:04AM
Brandon Smith Wrote:
------------------------------------------------------- > Hi All, > I recently purchased a laser engraver to engrave > cork handle. Im wondering if a person can or > should put some kind of clear coat over it help > protect and preserve the engraving. Any thoughts, > comments, or tips are appreciate. Are you possibly going to do this as a service or just personal use? Re: Cork Handle Engraving
Posted by:
Brandon Smith
(---.midco.net)
Date: May 23, 2019 08:10PM
As of now personal Sorry, only registered users may post in this forum.
|