SPONSORS
2024 ICRBE EXPO |
Does anyone make a 15mm OD poly arbor?
Posted by:
Chris Henry
(---.twcny.res.rr.com)
Date: April 20, 2019 07:04AM
I’m looking for a perfect fitting poly arbor for the Fuji VSS 16-15. Re: Does anyone make a 15mm OD poly arbor?
Posted by:
Michael Danek
(---.alma.mi.frontiernet.net)
Date: April 20, 2019 03:40PM
If you strike out these things are a piece of cake to turn down to a smaller diameter. Especially on a drill press. Take a regular drill bit just a little bigger in diameter than the ID of the shim, twist it into the bore of the shim about an inch, then mount it into your drill press. Spin it and use coarse sandpaper to turn it down. Careful, they machine very easily and fast. Re: Does anyone make a 15mm OD poly arbor?
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: April 20, 2019 05:17PM
Fuji's NSA16S arbors fit all Fuji spinning reel seats. Re: Does anyone make a 15mm OD poly arbor?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: April 20, 2019 09:22PM
10-4 on Michaels comment.
I generally buy size 17 arbors and turn each one down by chucking a rod in a variable speed drill and mount the arbor on the rod. Then I hold the spinning arbor against my belt sander with the sander turned on and continue until the arbor is a perfect fit for the inside of the reel seat. Good luck Sorry, only registered users may post in this forum.
|