SPONSORS
2024 ICRBE EXPO |
Carbon fiber grips , [ FLY RODS ]
Posted by:
Bill Sidney
(---.gci.net)
Date: August 10, 2018 09:25PM
Utmost ENT, is handling ALPS carbon fiber grips for FLY Rods, on as needed, will supply , just a tidbit , William Sidney AK Re: Carbon fiber grips , [ FLY RODS ]
Posted by:
Bill Sidney
(---.gci.net)
Date: August 14, 2018 08:06PM
My new grips are in the mail as I type , FAST shipping will report on them in the next couple of days , William Sidney AK Re: Carbon fiber grips , [ FLY RODS ]
Posted by:
Bill Sidney
(---.gci.net)
Date: August 18, 2018 08:45PM
well I got the new FLY ROD GRIPS in today couple of things I notes t #1 was a little more costly than the other grips , # 2 the fit of the fiber on the foam grip was a lot tighter,
# 3 the ends of grips were finished off a lot better , # 4 the foam in the grip was a lot tighter , not so crumblly [course ] # 5 the out side of the foam grips were smoother did not have waves in it , if you only order one grip the at a time , the cost is about the same , the Baston grips were inlettered for recessed reel seats , as the on sale were not , I ordered 2 grips at a time in all cases , got 6 from a suppler that has them on sale, an 2 out of Batson , my feeling is that the Baston GRIP is a better GRIP bar none I only looked into the grips on sale & an Baston . not any other grips , good luck William Sidney AK Edited 1 time(s). Last edit at 08/19/2018 12:36AM by Bill Sidney. Re: Carbon fiber grips , [ FLY RODS ]
Posted by:
Bill Sidney
(---.gci.net)
Date: August 19, 2018 12:56PM
The halfwells is about 3/4 inch longer than ?? with a hole about .26 inch ID , Full wells about 3/4 inch longer than ?? with a hole about .36 inch ID, William Sidney AK Sorry, only registered users may post in this forum.
|