SPONSORS
2024 ICRBE EXPO |
Plate reel seat on carbon fiber?
Posted by:
Craig Clements
(47.197.110.---)
Date: October 21, 2017 08:12PM
Hello,
I want to use a plate reel seat on a saltwater Rod. I'm wondering if I do the carbon skinned foam for the underlying handle if it would have enough long term stability\durability or if I need to just go with the hard carbon tubes like the texalinium types? Thanks, Craig Re: Plate reel seat on carbon fiber?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: October 21, 2017 10:49PM
Hard carbon tubes would be my choice. Re: Plate reel seat on carbon fiber?
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: October 21, 2017 11:29PM
Craig,
The CFX type grips you see in the Mudhole catalog, can take a 130 lb. lady standing on them with no ill effects, I have one here she has tested for customers at least a half dozen times wil no noticable damage to the grip. I didn't think of this test, the guys who build them for Mudhole did the test and the gentleman who stepped on it was much closer to 160. Re: Plate reel seat on carbon fiber?
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: October 21, 2017 11:42PM
Craig,
The CFX type grips you see in the Mudhole catalog, can take a 130 lb. lady standing on them with no ill effects, I have one here she has tested for customers at least a half dozen times with no noticable damage to the grip. I didn't think of this test, the guys who build them for Mudhole did the test and the gentleman who stepped on it was much closer to 160. I have no idea what kind of rod you want to build, but these grips are pretty tough and have held up to seasons of use on salmon rods in rod holders. Re: Plate reel seat on carbon fiber?
Posted by:
David Miller
(---.triad.res.rr.com)
Date: October 22, 2017 10:00PM
I have my surf rods plate seats wrapped on carbon fiber hard tubes but with that said I don’t think wrapping them on a high density foam would be an issue. I have seen people wrap them on top of cork tape. Re: Plate reel seat on carbon fiber?
Posted by:
Craig Clements
(172.58.175.---)
Date: October 23, 2017 11:19AM
Thank you guys!
Do you think I should put on en extra coat over the carbon fiber or is the strength in the fiber not the epoxy? Sorry, only registered users may post in this forum.
|