SPONSORS
2024 ICRBE EXPO |
Pacbay minima reel seat measurements needed
Posted by:
Darren keats
(---.154.93.209.dyn.plus.net)
Date: December 18, 2016 05:41AM
Hi chaps,these are not available in England and no measurements are given on pacbay. Can some kind person please measure the od of where the seat will meet the grip. Need the trigger grip and spinning seat version measurements Many thanks
[www.anglersworkshop.com] Re: Pacbay minima reel seat measurements needed
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: December 18, 2016 10:32AM
They are sized with different IDs just like an exposed blank reel seat. The OD is also the same for both the spinning and casting, the spinning seat just has no trigger, about 1.1 inches if I remember right. The same as any 16, 17, and also 18 mm casting trigger reel seat I believe. Edited 3 time(s). Last edit at 12/18/2016 11:43AM by Spencer Phipps. Re: Pacbay minima reel seat measurements needed
Posted by:
Darren keats
(---.154.93.209.dyn.plus.net)
Date: December 18, 2016 01:44PM
Hi spencer,the ID does not concern me just an accurate measurement of the od where it will meet the cork/EVA etc. I am developing a new casting grip and need the precice measurement. Fuji has all the dimensions for their seats but pacbay and alps give nothing. Re: Pacbay minima reel seat measurements needed
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: December 18, 2016 02:57PM
Darren, Minima size 16 casting measures 26.3mm. outside, where it butts against rear grip. Re: Pacbay minima reel seat measurements needed
Posted by:
Donald R Campbell
(---.socal.res.rr.com)
Date: December 18, 2016 04:06PM
Darren,
I just mic'ed a 16 mm PacBay Minima split spinning reel seat and the O.D. measured 26.4 mm. Don Campbell don@sensorfishingrods.com Re: Pacbay minima reel seat measurements needed
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: December 18, 2016 04:26PM
Both the spin and trigger seats have the same OD. The inlet size on both about 22 mm.
Norm Re: Pacbay minima reel seat measurements needed
Posted by:
Darren keats
(---.154.93.209.dyn.plus.net)
Date: December 18, 2016 05:30PM
Many thanks for the measurements guys. When I launch my new products I will show you on here. Cheers for now,darren Sorry, only registered users may post in this forum.
|