SPONSORS
2024 ICRBE EXPO |
Finishing Graphite Rod Handle
Posted by:
Brody Haakenson
(---.gondtc.com)
Date: November 29, 2016 08:27PM
First off i'm new to the sight wish I would have found it years earlier. I am still new to the rod building sciences and have many things to learn and questions that need answers
For any of you who have used this type of handle what is the best finish to go over the handle with. I used prokote on one previous handle and I ended up having ripples in the finish. Is there a better option to finish this or is there a way to get rid of the ripples in the finish. Thanks in advance Here is the handle i'm using [www.mudhole.com] Re: Finishing Graphite Rod Handle
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: November 29, 2016 08:40PM
Top coat with permagloss looks good very durable and easy to do. Here is a U tube link by Tom Kirkman showing how to top coat a carbon fiber grips. If you do not have a lathe you can use a cordless drill.
[m.youtube.com] Norm Re: Finishing Graphite Rod Handle
Posted by:
Capt. Michael Harmon
(---.dyn.optonline.net)
Date: November 29, 2016 08:44PM
X2 Norman. That's how I finished a few. Re: Finishing Graphite Rod Handle
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: November 29, 2016 08:49PM
It's not necessary to finish graphite tube type spinning seat/grip. Re: Finishing Graphite Rod Handle
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: November 29, 2016 09:39PM
Spencer may be correct did not notice they were tube type woven graphite grips. Have not used these before, but I assume that a top coat with permagloss would not hurt.
Norm Re: Finishing Graphite Rod Handle
Posted by:
Kerry Burgess
(---.dhcp.embarqhsd.net)
Date: November 30, 2016 03:04AM
Nice video Tom, very informative. Now I would like to know what brand lathe you have and the entire setup including the chuck. I cannot find a lathe that I like. Your lathe is exactly what I am looking for. Hope you read this and point me in the right direction.
Thanks, Re: Finishing Graphite Rod Handle
Posted by:
Tom Kirkman
(Moderator)
Date: November 30, 2016 08:01AM
That particular lathe is no longer made, although there is a very similar unit in the company's line up. It's from OneWay Manufacturing in Canada and you should look at the model 1224. The one in the video is a 1018 which was replaced by the 1224 a few years ago. Virtually identical but the 1224 has a tad more bed length and a bit more swing.
............... Sorry, only registered users may post in this forum.
|