SPONSORS
2024 ICRBE EXPO |
kayak attachment for custom rods
Posted by:
Buzz Butters
(---.dhcp.fdul.wi.charter.com)
Date: September 29, 2016 07:54AM
Attaching lanyard - to custom kayak rods.
Looking for a way to incorporate a tie off point in the rear grip of the rod during the fabrication process of a custom grip. I would like to be able to build this during the grip process rather than after the rod is done. what has your experience been in attachments for kayak rods? Thanks, Buzz Re: kayak attachment for custom rods
Posted by:
Tom Kirkman
(Moderator)
Date: September 29, 2016 07:58AM
There was an article on soft attachment points for kayak rods in a past issue of the magazine. You can certainly get some ideas there.
Fashioning a nylon cord loop from the end of the butt cap is a good way. ................... Re: kayak attachment for custom rods
Posted by:
Barry Thomas Sr
(---.hsd1.nj.comcast.net)
Date: September 29, 2016 10:53AM
Velco Strap and a Phone cord Bungee Re: kayak attachment for custom rods
Posted by:
Donald R Campbell
(---.socal.res.rr.com)
Date: September 29, 2016 11:40AM
Buss,
I have only done one Kayak rod for a work buddy and I used a loop of heavy parachute cord and epoxied it under the back end of the front split grip. I then hooked a phone bungee cord to the loop and it worked great according to my buddy. Don Campbell don@sensorfishingrods.com Re: kayak attachment for custom rods
Posted by:
Buzz Butters
(---.dhcp.fdul.wi.charter.com)
Date: September 29, 2016 05:38PM
Thanks all Re: kayak attachment for custom rods
Posted by:
woody osborne
(---.dhcp.spbg.sc.charter.com)
Date: September 30, 2016 08:39PM
i sent you an email. Re: kayak attachment for custom rods
Posted by:
Buzz Butters
(---.dhcp.fdul.wi.charter.com)
Date: October 01, 2016 11:21AM
got it woody thanks Sorry, only registered users may post in this forum.
|