SPONSORS
2024 ICRBE EXPO |
guide spacing
Posted by:
Gord Stuart
(---.dsl.bell.ca)
Date: September 27, 2016 08:48PM
could use your help I am starting to build a 13'0" 4pcs Rainshadow float rod model # xst1563-4 I can not find the guide spacing for this blank
any help would be appreciated .. Gord Re: guide spacing
Posted by:
Ken Preston
(---.opera-mini.net)
Date: September 28, 2016 07:23AM
Best bet is to follow this article to set them: [www.rodbuilding.org] Re: guide spacing
Posted by:
Ken Finch
(---.ip-167-114-102.net)
Date: September 28, 2016 08:00AM
Batson has a page on their website that lists suggested guide spacings for most of their blanks. Re: guide spacing
Posted by:
Spencer Phipps
(172.58.39.---)
Date: September 28, 2016 10:01AM
Your email is hidden, my two piece was from the tip, 4,9,15,22,30,39,49,60,72,85,99.5,115.5, should get you close. Re: guide spacing
Posted by:
Jay McKnight
(---.dhcp.aldl.mi.charter.com)
Date: September 28, 2016 04:34PM
This is the spacing I like on a 13' 4-piece spey/float conversion. This arrangement will most likely work out quite well on your XST also. This will place a guide right on each female ferrule, which is my preference, but certainly not a necessity.
5 11.25 18 25.25 32.75 40.5 48.75 57.75 67.75 78.75 898.75 102.5 116.5 Re: guide spacing
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: September 28, 2016 05:45PM
Use the KISS way google up spacing charts Find one that fits -- Or just start with 1 guide per foot Static test Add if needed or take away Test cast add - subtract and see No rules nothing in stone Bill - willierods.com Sorry, only registered users may post in this forum.
|