SPONSORS
2024 ICRBE EXPO |
Wonder Weaver
Posted by:
John Wright
(---.om.om.cox.net)
Date: May 04, 2016 10:43PM
Anyone own a Wonder Weaver? I was wondering what the diameter of the wheels are. They look to be about 6"?
Thanks. Re: Wonder Weaver
Posted by:
Tom Kirkman
(Moderator)
Date: May 05, 2016 08:29AM
You'd be pretty close but I seem to recall they're a bit larger than that. There were two versions and one may be a little smaller than the other.
................. Re: Wonder Weaver
Posted by:
Robert Metzger
(---.dyn.optonline.net)
Date: May 05, 2016 08:53AM
I just measured mine. I have the 3 wheel model. The wheels measure 3.8" + or - .010. Re: Wonder Weaver
Posted by:
John Wright
(---.om.om.cox.net)
Date: May 05, 2016 01:57PM
Thank you. I was thinking about that diameter. I am trying to build a clone, and at 4 nches using two degree increments, that puts the thread lines less than .1 inches apart. That is a little difficult to cut. At 6" the lines are .1 inch and are easier to handle. But 6" in diameter is pretty large. I may have to develop a better way to cut the thread holder.
Thanks. John Re: Wonder Weaver
Posted by:
Ken Preston
(---.opera-mini.net)
Date: May 06, 2016 08:14AM
There's a pretty good YOUTUBE video on line if you are interested - query "wonder weaver" & it should come up. Not a simple task Re: Wonder Weaver
Posted by:
Ken Preston
(---.opera-mini.net)
Date: May 06, 2016 08:14AM
There's a pretty good YOUTUBE video on line if you are interested - query "wonder weaver" & it should come up. Not a simple task Sorry, only registered users may post in this forum.
|