SPONSORS
2024 ICRBE EXPO |
Adding epoxy
Posted by:
Jim Alberts
(---.dhcp.aldl.mi.charter.com)
Date: February 09, 2016 08:22AM
About five years ago I built my first and only fly rod, apparently I
did a poor job on the finishing epoxy. The finish now has small blemishes and gray spots, can I simply add another light coat to the existing epoxy, I have no desire to completely remove the guides and start from scratch. The rod works very well and I am happy with how it casts, but if I could refresh it cosmetically I would certainly do it. Re: Adding epoxy
Posted by:
John E Powell
(---.dynamic.wnyric.org)
Date: February 09, 2016 08:36AM
Comments deleted Edited 1 time(s). Last edit at 09/20/2016 05:01PM by John E Powell. Re: Adding epoxy
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: February 09, 2016 09:49AM
John has good advice. But of course the best way to remedy the problem is to remove the old guide and rewrap the rod.
The current finish might have gotten some moisture under the finish that is causing the issue. If that is the case, putting more finish on top will not solve the problem. You could try recoating just one guide without doing anything to the rod and see what the results are. Be safe Re: Adding epoxy
Posted by:
Jim Levy
(---.prvdri.fios.verizon.net)
Date: February 09, 2016 01:17PM
If the gray spots and blemishes are surface scuffs only, recoating with new epoxy should cover them up. Test by wetting the surface of the old epoxy by dabbing alcohol on with your finger and see if the blemishes disappear when wet. Remove any flaking finish as John suggested, before the wet test. If wetting the surface cleared up the imperfections, lightly sand the old finish and apply a light coat of epoxy to cover the old. As Roger stated, the best remedy is to remove the old thread and finish and rewrap the rod. Sorry, only registered users may post in this forum.
|