SPONSORS
2024 ICRBE EXPO |
REPLACING DREAM REAMER SAND PAPER
Posted by:
Roger Pascual
(---.statefarm.com)
Date: January 21, 2016 06:36PM
AFTER 2 YEARS MY DREAM REAMERS FINALLY NEED REPLACING... SO MY QUESTION IS WHAT IS THE BEST METHOD TO REINSTALL THE SANDPAPER ON TO THE REAMERS.. Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: January 21, 2016 06:56PM
Contact cement. Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
Marc Morrone
(---.dsl.airstreamcomm.net)
Date: January 21, 2016 08:11PM
I have had good luck using Rod Bond. Thanks - Marc Keep it simple - that's all I can handle! Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
Bill Sidney
(---.gci.net)
Date: January 21, 2016 08:29PM
contact cement will last longer, I think because all epoxy is heat sensitive an contact is not as bad , as I see it William Sidney AK Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: January 21, 2016 09:05PM
Use contact cement it is much more heat resistant than epoxy. The first reamers I made, way back when, I used and old blank peice that I coated in paste epoxy and rolled in coarse grit. These reamers worked fine as long as I reamed by hand. When I used them in a hand drill all the grit came off because of the heat of friction. Since then used sand paper strips applied with contact cement, no problems reaming under power. Hope this helps.
Norm Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: January 22, 2016 07:41AM
By the way, if you happen to do a lot of rods that have the same size blank and thus need to be reamed out the same, you can now and then find deals on machine shop reamers. Often a shop closes down and sells all of the tooling for a fraction of the new cost.
The new cost of machine shop reamers is rather high, but if you can locate the correct one, a machine shop reamer does a wonderful job reaming and it will never wear out reaming any of the common grip materials like wood, cork, eva etc. [www.amazon.com] [www.amazon.com] Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
Roger Rierson
(---.triad.res.rr.com)
Date: January 22, 2016 09:45AM
Go to Baston website, they have tips on replacing sandpaper on their reamers. Re: REPLACING DREAM REAMER SAND PAPER
Posted by:
Roger Pascual
(---.statefarm.com)
Date: January 22, 2016 12:34PM
THANKS GUYS FOR ALL THE TIPS. LOOKS LIKE ILL BE SNIFFING CONTACT CEMENT TONIGHT..... inscription on fly rod
Posted by:
Robert Kelsey
(---.lightspeed.rcsntx.sbcglobal.net)
Date: January 22, 2016 07:55PM
Thanks for the suggestions . I'll give it go. Sorry, only registered users may post in this forum.
|