SPONSORS
2024 ICRBE EXPO |
MHX winn grip
Posted by:
Juan Jose
(---.216.141.31.dyn.user.ono.com)
Date: July 15, 2015 05:34AM
Hi, I´m building a finesse spinning rod for bass. The Blank is a MHX HM SJ841.
I want to build it with Aero reel seat in size 17 because I have big hands. So the first question; winn grip or not? If not I would put eva grip. I have never tested the winn grip, so I doubt. I like the MHX winn grip but I have seen it would be in 16 size. So the second question, if I decide mhx winn grip, I should buy the aero reel seat in size 16 or I can fit the MHX winn grip with the aero 17? Thanks!! Re: MHX winn grip
Posted by:
Tom Kirkman
(Moderator)
Date: July 15, 2015 11:32AM
The folks at Mudhole should be able to tell you if that grip will fit the 17 seat. I'd give them a call or an email to find out.
.............. Re: MHX winn grip
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: July 15, 2015 09:55PM
The 17mm aero seat is sized to except a standard 1.0 to 1.1 inch diameter cork grip, same size that goes behind a 16 -18mm casting reel seat. I bet the MHX casting split grip, or full length rear grip will slide right into the pocket. Re: MHX winn grip
Posted by:
Todd R. Vivian
(---.se.biz.rr.com)
Date: July 21, 2015 08:56AM
Spencer is correct, get the FSG-387 grip and it will work fine with the Aero-17
Todd Regards, Todd Vivian Mud Hole Custom Tackle todd@mudhole.com Re: MHX winn grip
Posted by:
Chris Richer
(131.137.243.---)
Date: July 21, 2015 09:24AM
But will the MHX-RSG3T fit behind a Aero 17 spinning grip? Chris Richer Iroquois ON Re: MHX winn grip
Posted by:
Juan Jose
(---.216.141.31.dyn.user.ono.com)
Date: July 25, 2015 03:25AM
That is the question!!!! Sorry, only registered users may post in this forum.
|