SPONSORS
2024 ICRBE EXPO |
Fuji VSSM seat with custom EVA grips
Posted by:
mick vickers
(---.a1a.zs.ncren.net)
Date: May 08, 2015 10:26AM
I am using this seat and making a custom grip. what is the best way to cut the EVA to match the contours of the seat, X-Acto? I have ordered a stock seat to use as a pattern.
Thanks, Mick Re: Fuji VSSM seat with custom EVA grips
Posted by:
Billy Vivona
(---.nycmny.fios.verizon.net)
Date: May 08, 2015 11:31PM
THrow the seat away and use a different one Re: Fuji VSSM seat with custom EVA grips
Posted by:
Tom Kirkman
(Moderator)
Date: May 09, 2015 07:41AM
If you're going to try the Xacto knife route, trace a pattern onto some paper held to the seat. Then transfer that to the grip. Leave some additional length on the grip, in case of a screw-up. That way you can trim back and try again.
................... Re: Fuji VSSM seat with custom EVA grips
Posted by:
mick vickers
(---.a1a.zs.ncren.net)
Date: May 11, 2015 01:25PM
can't throw it away Billy, it's already in the mail to you!! Sorry, only registered users may post in this forum.
|