SPONSORS
2024 ICRBE EXPO |
Reel seat parts
Posted by:
Ed Bingle
(---.cableusa.cc)
Date: April 22, 2015 11:34AM
Hello everyone
New member first post. I would like to find a good resource for reel seat hard ware without the insert. Can anyone make suggestion? I have read through a lot of post and find this forum to be one of the best. Re: Reel seat parts
Posted by:
Ron Schneider
(---.mthmcmta01.res.dyn.suddenlink.net)
Date: April 22, 2015 12:50PM
We have "skeleton" seats in Cast, Fly, and Spin.
Give us a holler with your needs. Best wishes, Ron Schneider Schneider's Rod Shop Mountain Home, Arkansas [www.schneidersrods.com] mtnron40@yahoo.com 870-424-3381 Re: Reel seat parts
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: April 22, 2015 06:08PM
Many manufacturers make, and many of the suppliers on the left carry reel seat skeletons. Re: Reel seat parts
Posted by:
Ron Weber
(---.ph.ph.cox.net)
Date: April 23, 2015 06:59AM
Unhide your email Re: Reel seat parts
Posted by:
Ed Bingle
(---.cableusa.cc)
Date: April 23, 2015 07:53AM
Thanks for the replies. I am sorry I was not more informative about my request. I am looking for skeleton real seats that are metal. Cast, spin and fly. that are not too pricey. I am experimenting with custom inserts and may mess up a few. I could even make do with some used ones. Build your dreams and dream what your going to build. Re: Reel seat parts
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: April 23, 2015 05:35PM
Ed,
I think that the selection of metal casting and spinning skeletal reel seats is extremely limited or perhaps non existent. However there is a wide selection of graphite skeletal reel seats in all sizes and shapes. There are a few Fly rod metal skeletal reel seats. If you want, you can always take a metal full reel seat and use a band saw to cut the middle out of it to create a skeletal reel seat. [www.google.com] Click on the picture to take you to the link for that picture. Be safe Re: Reel seat parts
Posted by:
Ed Bingle
(---.cableusa.cc)
Date: April 24, 2015 06:24AM
Thank you roger.
I believe this is the way I am going to go. Cutting up reel seats looks like the only option I have in the cheap. After I figure what I am doing then I can move up to something more expensive. Re: Reel seat parts
Posted by:
George Forster
(---.hsd1.co.comcast.net)
Date: April 25, 2015 12:22PM
Ed,
Check out the prices at Schneider's on aluminum seats: [www.schneidersrods.com]. George Forster Fort Collins, CO Sorry, only registered users may post in this forum.
|