SPONSORS
2024 ICRBE EXPO |
Flex coat finish application chuck with clutch
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: December 27, 2014 11:15AM
I just finished up a build of a motor unit for a fellow rod builder to use one of the very excellent Flex Coat finish application chucks that uses an integrated slip clutch system on the unit.
After working with it for a bit, I understand the concept and the beauty and well made properties of this Chuck. I am sure, as I found out, that any one who buys such a unit will be well pleased to use this chuck with a higher speed motor for applying finish to a rod in a very easy and quick fashion. [www.flexcoat.com] Really great product. Well worth the money. Be safe Re: Flex coat finish application chuck with clutch
Posted by:
Tom Wewerka
(---.bltmmd.fios.verizon.net)
Date: December 27, 2014 09:07PM
Roger you are right on, it is an excelletnt product. It makes application of finish a breeze.
Another thing about it too, is your rod won't come out of it while curing which has been a frequently asked question on this forum. Tom Re: Flex coat finish application chuck with clutch
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: December 28, 2014 07:19AM
Tom,
10-4. I have made a bunch of similar chucks for use on my dryers and they work very well indeed. They are the basis for simplicity. Just a 59 cent pvc end cap and a piece of neoprene stretched across the end with a hole punched in the middle of the neoprene. However, I will say that flex coat does have a better product, since their cups are molded with the bearing shaft hole in place and their rod holding membrane is pre shaped to fit the cup. Great product at a reasonable price. Be safe Re: Flex coat finish application chuck with clutch
Posted by:
Bob Jumper
(---.zoominternet.net)
Date: December 28, 2014 07:43PM
Roger,
If your setup doesn't have a 1/4" shaft, would the shaft on the slip clutch lock into a 3 jaw chuck? Thanks, Bob Re: Flex coat finish application chuck with clutch
Posted by:
Tom Wewerka
(---.bltmmd.fios.verizon.net)
Date: December 28, 2014 09:01PM
Bob
I use my flex coat slip clutch on an Alps 3 jaw chuck. Works great and has Never come loose while curing. Tom Re: Flex coat finish application chuck with clutch
Posted by:
Bob Jumper
(---.zoominternet.net)
Date: December 29, 2014 05:35AM
Thanks Tom, I'll have to try one out.
Bob Re: Flex coat finish application chuck with clutch
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: December 29, 2014 11:13AM
Bob,
Certainly. As long as the jaws will open to the size of the out side of the shaft, any chuck on a wrapper or drill will hold the flex coat shaft just fine. Be safe Re: Flex coat finish application chuck with clutch
Posted by:
Kevin Kelly
(---.hsd1.ga.comcast.net)
Date: January 01, 2015 02:03PM
That chuck has been on my wish list for a while now. Sorry, only registered users may post in this forum.
|