SPONSORS
2024 ICRBE EXPO |
Renzetti Lathe
Posted by:
Ed Fontes
(---.hsd1.ma.comcast.net)
Date: August 18, 2014 07:07AM
I just got a new Renzetti Lathe and have set it up, the thread carriage does not move up and down the rod as it should, it will wind about 1/2" and then back over itself, I ve loosened both the thread tension and the carriage tension with no change, any help would be appreciated Re: Renzetti Lathe
Posted by:
Tom Kirkman
(Moderator)
Date: August 18, 2014 08:00AM
I'm not quite sure what you're saying - you are aware that you have to move the carriage by hand, right? It doesn't roll along on it's own.
...................... Re: Renzetti Lathe
Posted by:
Ed Fontes
(---.hsd1.ma.comcast.net)
Date: August 18, 2014 08:37AM
Hi Tom
Did not know that, instructions aren't that good, my AT moved on its own cant believe this doesn't Re: Renzetti Lathe
Posted by:
Spencer Phipps
(---.war.clearwire-wmx.net)
Date: August 18, 2014 09:46AM
The thread carriage has a bit more mass on the Renzetti. Re: Renzetti Lathe
Posted by:
Randolph Ruwe
(---.hsd1.wa.comcast.net)
Date: August 18, 2014 03:17PM
That is what the knob on the front of the carriage is for, to advance it as you use your foot control to spin the rod while wrapping. Sorry, only registered users may post in this forum.
|