SPONSORS
2024 ICRBE EXPO |
Area 51 complete
Posted by:
Jim Ising
(---.dyn.centurytel.net)
Date: June 27, 2014 02:50PM
Looks like we are about finished with the R&D center. Plenty of little bugs to be worked out but seems to be functional and well thought out so far. Thanks to all who helped with suggestions and comments as the place evolved. Only thing missing is my light...still hasn't arrived yet. Here are a few pics of the results. Thanks again.
[www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] Re: Area 51 complete
Posted by:
Donald R Campbell
(---.lsanca.fios.verizon.net)
Date: June 27, 2014 03:06PM
Jim,
That really nice. I wish I had my rod building shop inside, (with the air conditioning). The summers get too hot here in CA! Don Campbell don@sensorfishingrods.com Re: Area 51 complete
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: June 30, 2014 09:30AM
Hope you have a dust collector planned for your lathe station. I make a large mess with mine in the garage.. Nice layout and a bright clean look.
Well done. Terry Re: Area 51 complete
Posted by:
Robert A. Guist
(---.dhcp.embarqhsd.net)
Date: June 30, 2014 01:49PM
Hello Jim.
Is the lathe going to be using the electric cord set-up you show in your picture? If you do the trip hazard is HIGH! Good Luck. Bob, New Bern, NC. Re: Area 51 complete
Posted by:
Jim Ising
(---.dyn.centurytel.net)
Date: July 01, 2014 09:14AM
Robert I was surprised to notice that there is no plug on the wall at the lathe. I will eventually do something more permanent, was just checking to see that it made the move in good shape. Sorry, only registered users may post in this forum.
|