SPONSORS
2025 ICRBE |
Fuji ECSM Seat
Posted by:
J.B. Hunt
(---.ppoe.dsl.logantele.com)
Date: April 22, 2014 01:09PM
I am building a MHX CCB865 for a client. He wanted an ECSM seat. The largest I have on hand in a size 16 is 14 mm and it is too small. Will a 15 mm ream out to fit this blank ? Where it sits , it measures 16.5 mm. I don't want to go to a size 17 if I can keep from it. J.B.Hunt Bowling Green, KY Re: Fuji ECSM Seat
Posted by:
Jim Ising
(---.dyn.centurytel.net)
Date: April 22, 2014 02:09PM
Would not recommend it. There are no "tabs" in the 15 so you would immediately be reaming the wall thickness of the threaded barrel and the open area where the blank is exposed. I don't think it will take a 1.5mm expansion. Re: Fuji ECSM Seat
Posted by:
Joe Vanfossen
(---.neo.res.rr.com)
Date: April 23, 2014 01:08AM
J.B.
If you have to go to the 17, get both the ECSM and the full seat for him to try, if possible. Personally, I don't find the 17mm exposed blank seats nearly as comfortable. My fingers just don't lay on them as well, and I find the full seat much more comfortable in that size. Joe Re: Fuji ECSM Seat
Posted by:
J.B. Hunt
(---.ppoe.dsl.logantele.com)
Date: April 26, 2014 10:27AM
I will definitely try that. Thanks Joe. J.B.Hunt Bowling Green, KY Sorry, only registered users may post in this forum.
|