SPONSORS
2024 ICRBE EXPO |
removing a alluminum reel seat?
Posted by:
mike johnson
(---.dhcp.unas.wa.charter.com)
Date: January 19, 2014 11:58AM
ive never tried this so looking for a few tips... i know this seat is epoxied and sitting on two spacers of masking tape on each end, so if i make say three or four cuts lengthwise are they likely to pry apart? thanks Re: removing a alluminum reel seat?
Posted by:
David Parsons
(---.hsd1.pa.comcast.net)
Date: January 19, 2014 12:53PM
I have had good luck with a small cut off wheel doing that on reel seats Re: removing a alluminum reel seat?
Posted by:
Russell Brunt
(---.mia.bellsouth.net)
Date: January 19, 2014 02:24PM
One spiral cut works best for me. Get a screwdriver in the slot, turn it, and you can generally "pop" it right off. Russ in Hollywood, FL. Sorry, only registered users may post in this forum.
|