SPONSORS
2024 ICRBE EXPO |
Looking for some Parts - any help is appreciated
Posted by:
Ron Beagles
(---.lightspeed.tblltx.sbcglobal.net)
Date: November 24, 2013 01:01PM
Looking to buy winding check for surf rod, at least two, black or dark brown - .920 od
black butt cap 3" long / 1." I any help thanks Re: Looking for some Parts - any help is appreciated
Posted by:
Robert A. Guist
(---.dhcp.embarqhsd.net)
Date: November 24, 2013 07:01PM
Hello Ron.
For the Butt Cap MudHole has a 3" X 1" RVB10 for $1.44, Black Rubber/Vinyl. As for the Winding Check I know of no .920 metal checks, the biggest Rubber/Vinyl is .950 next one down is .900, but I Think the .900 will stretch to .920. I myself would make my own out of Epoxy with a bit of black Testors in Each Batch of Epoxy (one that big will take a few runs with the epoxy), or you can build it from Rod Bond then the testors in the regular epoxy. Lots of way's. Tight Wraps. Bob, New Bern, NC. Re: Looking for some Parts - any help is appreciated
Posted by:
Ron Beagles
(---.lightspeed.tblltx.sbcglobal.net)
Date: November 24, 2013 09:55PM
never built one, how do you do tthat? Re: Looking for some Parts - any help is appreciated
Posted by:
Robert A. Guist
(---.dhcp.embarqhsd.net)
Date: November 25, 2013 06:22AM
Hello Ron.
It's simple but takes some patients. Just mix up your favorite epoxy and let it get kind of thick then put it where you want the winding check while turning the rod on a low RPM rod dryer till just barely tacky then repeat. It usually takes a few additions till it is as thick as you want. Tight Wraps. Bob, New Bern, NC. Re: Looking for some Parts - any help is appreciated
Posted by:
Ryan McBride
(---.wavecable.com)
Date: November 27, 2013 02:29PM
We have a whole lineup of Surf rods!! We are also blowing them out through our vendors!!
check out our website for information: www.batsonenterprises.com Home of: RainShadow, Alps, ForeCast Re: Looking for some Parts - any help is appreciated
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: November 27, 2013 02:39PM
Where is a link - on your site - of vendors
I liked the old site a lot better Bill - willierods.com Sorry, only registered users may post in this forum.
|