SPONSORS
2024 ICRBE EXPO |
Micro guide holder
Posted by:
chip burdick
(---.60.130.174.dynamic.ip.windstream.net)
Date: September 08, 2013 11:58AM
I just posted on the photo page a couple pictures of micro guide holders for small diameter blanks. I use fuel line for R/C cars and heli's and slice them about a 1/16" long or so. Slide them on and attach guide under. After I start the wrap I simply cut it off. The cost is about $1.50 a foot and I get hundreds of them. I don't know how to share the link or I would. I am computer challenged,lol. It's in the equipment section of the photo page. Re: Micro guide holder
Posted by:
Steve Hartzell
(---.drdrcmta01.drdrla.by.dh.suddenlink.net)
Date: September 08, 2013 09:36PM
I've been dealing with this all weekend. I'm using the tubing that Mudhole sells and it works very well. However, when I get to the last couple of guides near the tip, the diameter of the tubing is too large to hold the guide on the blank. The tubing you are using looks like just what I need. Thanks Steve Hartzell Lake Conroe - Willis, Texas Re: Micro guide holder
Posted by:
chip burdick
(---.twcny.res.rr.com)
Date: September 08, 2013 09:42PM
Any R/C store. I am lucky to have one a half mile from me. I does work great and is cheap. They have all sizes. Re: Micro guide holder
Posted by:
Skipp Hughes
(---.neo.res.rr.com)
Date: September 08, 2013 10:07PM
I have been using that tubing for years Works Great Re: Micro guide holder
Posted by:
Mike Pedersen
(---.ec.res.rr.com)
Date: September 08, 2013 11:25PM
Towards the tip or on real small diameter blanks wrap the tubing twice and put the'x' on the bottom. Use one part for the foot, the other as a stop to keep it from pushing forward.
[www.rodbuilding.org] ..... Riley Rods-Hard Core Grips to Go!-----Carbon Fiber - Composite Grip Store-----Capt Mike's Blog-----No Excuses Fishing Charters Re: Micro guide holder
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: September 09, 2013 08:45AM Re: Micro guide holder
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: September 09, 2013 10:52AM
Guidefoot adhesive. Works great and lasts forever.
Terry Re: Micro guide holder
Posted by:
Chris Tulk
(---.dsl.bell.ca)
Date: September 09, 2013 09:13PM
Hi Chip
Thanks for posting the pic. However I am trying to understand the picture and it doesn't look like the tubing is even wrapped around the blank? I find the micro guides really hard to hold to the blanks! Re: Micro guide holder
Posted by:
Mike Pedersen
(---.ec.res.rr.com)
Date: September 09, 2013 09:24PM
It's one slice of tubing doubled-up with the twist on the bottom.. Keeps the guide real snug.
..... Riley Rods-Hard Core Grips to Go!-----Carbon Fiber - Composite Grip Store-----Capt Mike's Blog-----No Excuses Fishing Charters Sorry, only registered users may post in this forum.
|