SPONSORS
2024 ICRBE EXPO |
Help please - CP follow-up on open wraps
Posted by:
Mike Rademacher
(---.dyn.optonline.net)
Date: July 17, 2013 01:57PM
Howdy
Quick follow-up... I opted to CP the whole section of decorative wrap including the open spaces of exposed blank... i was careful to wick away globs, blobs, puddles etc The blanks is high gloss and i can see light brush marks from the CP.. will those go away under the epoxy when finish is applied or am i in troubled waters if i can see them before finish... thanks and sorry for newbie question mike Re: Help please - CP follow-up on open wraps
Posted by:
Forrest Peters
(---.wi.res.rr.com)
Date: July 17, 2013 03:19PM
What do you mean lite brush marks? As long as you wiped up the cp and you covered your thread and let it dry. You should be good to go. Lone Wolf Rods "Keep your powder dry and your lines wet" God Bless Re: Help please - CP follow-up on open wraps
Posted by:
Randolph Ruwe
(---.hsd1.wa.comcast.net)
Date: July 17, 2013 04:04PM
The finish should make any brush marks on the blank in the CP invisible. Go for it!! Re: Help please - CP follow-up on open wraps
Posted by:
Mike Rademacher
(---.dyn.optonline.net)
Date: July 17, 2013 04:42PM
Thanks for the quick feedback... i am "all in" at this point.... will post some pix when the finish goes on in the next day or so...
really appreciate the guidance this board shares and provides. thanks again mike Re: Help please - CP follow-up on open wraps
Posted by:
Forrest Peters
(---.wi.res.rr.com)
Date: July 21, 2013 04:04PM
Let me know how it turned out. This is the best place to get good information. Lone Wolf Rods "Keep your powder dry and your lines wet" God Bless Sorry, only registered users may post in this forum.
|