SPONSORS
2024 ICRBE EXPO |
Rod Bond containers cracked
Posted by:
J.B. Hunt
(---.ppoe.dsl.logantele.com)
Date: July 06, 2013 11:42AM
Just wondering if anyone else has seen this problem. The last 2 kits of Rod Bond I purchased had tiny vertical cracks in the containers. I noticed the outside of the containers were greasy, sticky. After a close inspection, I found each container had 1 or 2 tiny vertical cracks and the materials were leaking out. I wonder if U-40 is aware of this since the containers are vacuum wrapped after filling. J.B.Hunt Bowling Green, KY Re: Rod Bond containers cracked
Posted by:
Tom Kirkman
(Moderator)
Date: July 06, 2013 12:13PM
Most likely they were damaged in shipping - something may have crushed the case box they were in. Tell your dealer to check the others they got in the same shipment.
............. Re: Rod Bond containers cracked
Posted by:
john timberlake
(---.triad.res.rr.com)
Date: July 06, 2013 07:07PM
Jay just wrap the containers in saran wrap and they will be fine without getting the contents all over everything Re: Rod Bond containers cracked
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 06, 2013 09:26PM
Take DNA and wipe the containers clean.
Then, use clear packing tape to give a nice clean finish on the outside surface of the containers. Should be good to go. Re: Rod Bond containers cracked
Posted by:
J.B. Hunt
(---.ppoe.dsl.logantele.com)
Date: July 06, 2013 11:26PM
I wrapped them with electrical tape after cleaning them good with alcohol. This has happened , I think twice, in the past couple of years. The last kit was a 32 oz, kit I got at the Show in Feb. and both containers were cracked. Doesn't bother me. Probably due to rough handling during shipping. Seems strange that I am the only one so far that's noticed this. J.B.Hunt Bowling Green, KY Re: Rod Bond containers cracked
Posted by:
Lindsay PELLETIER
(---.w92-140.abo.wanadoo.fr)
Date: July 07, 2013 05:44AM
You're not the only one, my last kit of 32oz of Rod Bond have the same failure (international shipping). Sorry, only registered users may post in this forum.
|