Hello .

Since i held some NFC Blank , i think I must make an effort to find the good blanks for me.

My old CCS data blank from Noth Fork Composite don't have it for this NFC MB 807 HM .
Or some other either.

I can't find CCS data on the NFC site . Yet two years ago, I could still ...

Could someone please provide it to me?

Thank you !

Didier .



Edited 1 time(s). Last edit at 05/30/2013 10:58AM by didier stephan.

NFC used to list that info for all their blanks. I think Jason Borger even designed the fly blanks to be spot on to the CCS numbers.

I think you mean Loomis not Borger.

No, I meant Jason Borger. He worked up the NFC fly blanks.

Ken, if by NFC, Didier means North Fork Composits, these Gary Loomis blanks and his web site states that "each blank was meticulously designed by Gary Loomis!" I believe that Borger was involved with another manufacturer.

NFC, North Fork Composites, sure made a big deal out of Jason Borger working on their fly blanks and tuning them to the CCS specs. If their older blog entries are still online you can read all about it.

Hello .

When i go on their blog , on this particulary page , named : " NFC Available Blank Stats "

I read : " STATS OFF-LINE. BE BACK SHORTLY! "

Ken , what do you mean when you says " their older blog entries are still online you can read all about it. "

Happily , i have the ability to hold it , because my dealer is not to far away from me . And he's got it !

But he just have few blank from NFC , and there is numerous other blank that could fit to my need .

It is in these conditions that CCS data are very useful then.
Unless we can try or have feedback very detailed.

I have to build a Travel blank jig to get CCS data from blank , when i drive to my dealer .

Didier.

Hello .

This afternoon , i drove to my dealer to test / purchase some blank .

Here are some data that i collected :

NFC MB807 HM :
Length : 242.7cm
Working length :211.7cm.................... deflection :70.56cm
Power :591.1g ( 20.84 oz )
TA: 59°

(I didn't have time to test it with the strict CCS way ....)
The weight was not applied exactly at the tip , but 3/4 cm above. I assume it change the data a little .
So the right Power should be less.
And TA should be a little more ...

Now that i purchased it , i will test it with rigor .

D.