SPONSORS
2024 ICRBE EXPO |
Tour Star grip boring
Posted by:
Mike Canavan
(---.stny.res.rr.com)
Date: April 30, 2013 07:20AM
I would like to enlarge the opening of a Tour Star (rubber) grip to accommodate a larger-diameter casting blank, just wondered what would be the best tool for the job. (Dream Reamer?)
Appreciated, Mike Re: Tour Star grip boring
Posted by:
Don Ahart
(---.hsd1.nj.comcast.net)
Date: April 30, 2013 08:01AM
I use a dream reamer on those works fine Edited 1 time(s). Last edit at 04/30/2013 08:03AM by Don Ahart. Re: Tour Star grip boring
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: April 30, 2013 09:18AM
A lathe and a large diameter drill bit works very well, with a good rod support at the tail stock end of the grip. Re: Tour Star grip boring
Posted by:
Mike Canavan
(---.stny.res.rr.com)
Date: April 30, 2013 03:34PM
Thanks very much Don & Roger, will give the reamer a try. Sorry, only registered users may post in this forum.
|