SPONSORS
2024 ICRBE EXPO |
Batson Woven Graphite Foregrip
Posted by:
Mitch Leppelmeier
(---.dsl.bcvloh.sbcglobal.net)
Date: February 20, 2013 11:49AM
Was just wondering if anyone knows if the woven graphite foregrips from batson will fit in an american tackle aero reel seat? Re: Batson Woven Graphite Foregrip
Posted by:
Joe Vanfossen
(---.housing.res.kent.edu)
Date: February 20, 2013 12:21PM
The OD of the widest end is about 1.05". I'm not sure what the ID of the Aero is, but I bet you could trim one to fit no problem. I've built up some split grips with the woven fore grips, and they are fantastic, but sleeving foam cores is much more cost effective.
Joe Re: Batson Woven Graphite Foregrip
Posted by:
Ron Weber
(---.ph.ph.cox.net)
Date: February 20, 2013 04:11PM
The Aero ID is right at .960 to .964 on the 2 I have here in stock. Ron Weber Re: Batson Woven Graphite Foregrip
Posted by:
Mitch Leppelmeier
(---.dsl.bcvloh.sbcglobal.net)
Date: February 21, 2013 10:14AM
is that measurement for the sz 16 or sz 17 aero? Re: Batson Woven Graphite Foregrip
Posted by:
Ron Weber
(12.70.3.---)
Date: February 21, 2013 10:25AM
That is for the 16, do not have any of the 17's in stock. Ron Weber Re: Batson Woven Graphite Foregrip
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: February 21, 2013 01:16PM Re: Batson Woven Graphite Foregrip
Posted by:
Ron Weber
(---.ph.ph.cox.net)
Date: February 21, 2013 09:24PM
That doesn't tell you anything but the inner ID, not a thing about the receiving hood that covers the cork or eva ID that I can see. Ron Weber Re: Batson Woven Graphite Foregrip
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: February 22, 2013 09:17AM
What about shaping a different material to fit the seet and then have the woven tube slide up to it
Just a thought Bill - willierods.com Sorry, only registered users may post in this forum.
|