SPONSORS
2024 ICRBE EXPO |
Rod holder for static distribution test
Posted by:
Matt Caplis
(---.hsd1.in.comcast.net)
Date: December 30, 2012 12:18PM
Hi everyone. I've searched, but not found what I was looking for on here. I want to build something to hold a fishing rod while under a load, and doing the guide placement. Does anyone have pics they would be willing to share of something they built? Thank you all! Re: Rod holder for static distribution test
Posted by:
George Forster
(---.hsd1.co.comcast.net)
Date: December 30, 2012 12:47PM Re: Rod holder for static distribution test
Posted by:
Joe Vanfossen
(---.neo.res.rr.com)
Date: December 30, 2012 02:27PM
What types of rods are you building? For freshwater rods, the duplicator board from Swampland (I think Mudhole has them too) works well. You can put two blanks on at the same time to compare their action and power, and it also works well for holding rods while static testing. For heavy duty rods, you will need to go for something more along the lines of the one George posted. Mudhole has an option along those lines as well.
[www.swamplandtackle.com] [www.mudhole.com] Joe Re: Rod holder for static distribution test
Posted by:
Matt Caplis
(---.hsd1.in.comcast.net)
Date: December 30, 2012 05:21PM
Thanks for the input. Joe, right now I'm building bass rods. Re: Rod holder for static distribution test
Posted by:
gaston arnold
(---.pools.spcsdns.net)
Date: December 30, 2012 06:22PM
I use a rod holder I stole off my drift boat.its angle adjustable and I mounted it to my bench Re: Rod holder for static distribution test
Posted by:
Barry Thomas Sr
(---.hsd1.nj.comcast.net)
Date: December 30, 2012 08:04PM
The one above that George posted is Mine I still use it for Stand-ups. For lighter rods I use a Alum pipe Screwed to the Side of my Cabinet,it works well
[www.rodbuilding.org] Edited 1 time(s). Last edit at 12/30/2012 08:07PM by Barry Thomas Sr. Re: Rod holder for static distribution test
Posted by:
John Locke
(---.phlapa.fios.verizon.net)
Date: December 31, 2012 03:27PM
I just used a piece of pvc tubing clamped in my vise at an appropriate angle. I 'think' that it only serves to hold the rod while you put a bend to it. Re: Rod holder for static distribution test
Posted by:
J.B. Hunt
(---.ppoe.dsl.logantele.com)
Date: December 31, 2012 10:15PM
I bought a plastic rod holder from Wallyworld for 9 bucks and bolted it to the end on one of my 10 ft work benches. It angles any direction. Sorry, only registered users may post in this forum.
|