SPONSORS
2024 ICRBE EXPO |
Weaving Jig
Posted by:
Pat Connor
(---.hsd1.tx.comcast.net)
Date: December 02, 2012 12:31AM
Any suggestions on where to buy a jig that bolts to the blank . I saw one in a video that had a spring on the right hand side . As luck would have it I have no way of finding the video . Re: Weaving Jig
Posted by:
Steve Mcleod
(---.104.244.87.dyn.jtglobal.com)
Date: December 02, 2012 01:54PM
I don't know if you were watching an old video, but there was a wooden loom available many years ago (I still have one) it had springs to hold the threads and bolts to clamp the loom to the rod. It's a bit of an antique now, i don't use it anymore, i doubt if anyone does now since the arrival of the jigs that are made with foam to hold the threads and much easier and quicker to use. Jersey, Channel Islands. (U.K.) Re: Weaving Jig
Posted by:
David Dosser
(---.columbus.res.rr.com)
Date: December 02, 2012 02:07PM
If you are looking to make a simple weaving jig, I have a tutorial on our Ohio rod builder's website. It's under Advanced techniques:
[ohiorodbuilders.wordpress.com] David Dosser Coshocton, OH Re: Weaving Jig
Posted by:
Pat Connor
(---.hsd1.tx.comcast.net)
Date: December 02, 2012 07:07PM
Thanks I will keep looking . Sorry, only registered users may post in this forum.
|