SPONSORS
2024 ICRBE EXPO |
Centerpin guides?
Posted by:
Tony Schollmeier
(---.washburn.k12.wi.us)
Date: November 30, 2012 03:07PM
I'm building myself a 13' float rod this winter - the biggest thing left for me to figure out is the guides. Very rarely will it be used in freezing weather so I'm not going to worry about that too much. I'm thinking a size 16 or 20 butt guide, possibly a high frame. Then a transition guide around an 8 or 10 spinning type. Then #6 low frame - fly style to the tip. I really want to minimize weight without limiting the function of the rod.
I've research quite a bit but am getting most hung up on guide material. Any recommendations from those with more experience with these kinds of rods? Would minimas be ok? Or would ceramics be better for smoother line flow when trotting downstream? The rod will be used on Lake Superior tribs and some warm water rivers if that makes some difference. Some of those spots will require lighter rigs and will have slower flows. Re: Centerpin guides?
Posted by:
Tom Kirkman
(Moderator)
Date: November 30, 2012 05:02PM
Minima's would likely be fine and offer a little larger ring opening per size and weight. As long as you know that #6's will pass your line and connections easily, there is little reason not to go that route. Freezing is not a problem for you, so it becomes fairly simple.
............. Re: Centerpin guides?
Posted by:
Dave Orr
(---.theedge.ca)
Date: December 01, 2012 10:10PM
Tony
I build a lot of CP rods and over time have come up with a good setup. I run 20, 12, 8 and then 6's, 7's or 8's on out to the tip depending on use. My own rods run 6's as I don't winter steelhead any more. I also use mid or high frames for the first 3 guides and single foot fly guides for the rest and a conventional tip top. I'm currently trying out the minima guides on a 13' Lamiglas that I'm going to build this winter. Any questions don't be afraid to ask. ;) Regards Dave Fishing is Life the rest is just Details Sorry, only registered users may post in this forum.
|