SPONSORS
2024 ICRBE EXPO |
Need help fitting a spinning rod
Posted by:
Kurt Mogensen
(---.142.96.50.dynamic.ip.windstream.net)
Date: November 22, 2012 07:42PM
I am building my first spinning rod for a friend's wife. He wants to use SiC guides. I don't know enough about sizing guides for such a light spinning rod and don't want to mess up on such an expensive guide set.
It is a 6.5' NFC blank (FW 602-1). I looked at the MH site and the recommended size for the YSG guides starts at a size 30 which seems large to me. It also recommends to finsh with the LSG-6 which is not included in the dropdown list. Also, the tip diameter is only 1.5mm. What is a recommended tiptop to use as I didn't see anything smaller than a 2.4mm? Any and all help is greatly appreciated. Re: Need help fitting a spinning rod
Posted by:
Tom Kirkman
(Moderator)
Date: November 22, 2012 08:43PM Re: Need help fitting a spinning rod
Posted by:
Jim Gamble
(---.res.bhn.net)
Date: November 22, 2012 09:52PM
This is also a good tool ... [anglersresource.net]. Re: Need help fitting a spinning rod
Posted by:
Eric MONTACLAIR
(---.fbx.proxad.net)
Date: November 23, 2012 12:45AM
Hi curt
Buy YSG 20/10(or 12)/7 and five LSG4 (if knot pass thru) and when in hand use the link Tom give you. You sould be OK. Re: Need help fitting a spinning rod
Posted by:
Kurt Mogensen
(---.142.96.50.dynamic.ip.windstream.net)
Date: November 24, 2012 08:06AM
Good stuff. Thanks guys. Sorry, only registered users may post in this forum.
|