I just purchased a bunch of Lamiglas blanks from Anglers workshot. They are Lamiglas International Sardina 6'6'' I665H 30-60 blanks. Do any of you have any ideas for the size and placement of the guides on them? i am going to use them for jigging halibut in Alaska. I plan on using a 10" slickbut and a 10" front grip if that matters. Thanks for your help!

Kevin Gross
Many men will spend their whole life wondering if they made a difference. Marines dont have that problem - Ronald Regan

Kevin,
Here is an answer that was posted some time ago on a 6'6" halibet rod:

-----------------


I live just south of the Canadian Boarder and you could say I know a bit about Halibut fishing up here. I use the TS66MH 6'6" Spiral Wrap

Rod Blank Model # TS66MH
Butt cap: BC17B
Front Cap:
Rear Grip: WHTS-12 with TRC-S trim rings on each side
Handle Arbor:
Reel Seat: CA-CAH22M-S
Reel Seat Shim
Foregrip: BSF14-625/750
Winding Check: TRS18-S
Hookeeper:
Tip Top SUZT12F11.5 180 degrees down from top of seat
1st guide from tip top XXNZG10 180 degrees from top of seat
2nd guide from tip top XXNZG10 180 degrees from top of seat
3rd guide from tip top XXNZG10 180 degrees from top of seat
4th guide from tip top XXNZG10 180 degrees from top of seat
5th guide from tip top: XXNZG10 180 degrees from top of seat
6th guide from tip top: XXNZG12 175 degrees from top of seat
7th guide from tip top: XXNZG16 145 degrees from top of seat
8th guide from tip top: XXNZG20 20 degrees from top of seat

Guide spacing Specs(inches from tip, center ring over mark) 3.25-6.5-10-13.5-18.325-24.5-31.5-39

Karry Batson
Batson Enterprises Inc.
Ph: (877) 875-2381
Fax: (360) 683-3579
karry@batsonenterprises.com
www.batsonenterprises.com