SPONSORS
2024 ICRBE EXPO |
Mark Crouse is building a Theme Rod
Posted by:
Chad Huderle
(76.164.57.---)
Date: August 27, 2012 09:41PM
Pulled Mark's book off the shelf this past weekend and read it again for the umpteenth time. Great book Mark. I was working on a tiger wrap and wasn't completely happy with the leveling of the finish. I decided to try sanding the finish as outlined near the end of the book and although I didn't feel brave enough to start with 60 grit sandpaper, I did use 180 and 220 and got very good results. One extra coat of finish and I think it turned out great. I added a picture to the photo section too.
Thanks Mark! Thanks, Chad Huderle Huderle Custom Rods Prior Lake, MN Re: Mark Crouse is building a Theme Rod
Posted by:
Col Chaseling
(---.lns8.cht.bigpond.net.au)
Date: August 28, 2012 03:58AM
Hi Chad,
Looks good. Mark does some wonderful stuff. I don't have a proper lathe but I'm still interested, where is his book available from? ESFNEM Col Port Kembla, NSW Australia Re: Mark Crouse is building a Theme Rod
Posted by:
Bill Eshelman
(---.neo.res.rr.com)
Date: August 28, 2012 12:30PM
We were very fortunate to have Mark as our guest at tthe first gathering of Ohio rod builders (ORBS). Mark demonstrated his Technique. It still worries me, but I do it with great results.
I`m sure at least a few of the sponsors to the left carry his book. If any one does not have it, you are really missing out. Bill Ohio Rod Builders Canton, Ohio Re: Mark Crouse is building a Theme Rod
Posted by:
mark crouse
(---.unassigned.ntelos.net)
Date: August 28, 2012 02:13PM
Hi guys
to dont fear the sand paper, just wipe it a lot of with alcohol and you will see where you at on depth. The Book is available through Mudhole. Mark Crouse Re: Mark Crouse is building a Theme Rod
Posted by:
Col Chaseling
(---.lnse2.cht.bigpond.net.au)
Date: August 28, 2012 06:03PM
Hi Bill and Mark,
Thanks, must have had my eyes shut the last time I looked through the Mudhole cattle dog. ESFNEM Col Port Kembla, NSW Australia Sorry, only registered users may post in this forum.
|