SPONSORS
2024 ICRBE EXPO |
Last Call
Posted by:
Tom Kirkman
(Moderator)
Date: April 24, 2012 06:45PM
Acclaimed wood turner and wood turning instructor Morris Schlesinger will be presenting a "hands-on" wood turning seminar on May 5th, 2013, at the RodMaker Magazine office and shop here in High Point. We're going to get underway about 9:30 AM and continue until about 3:30 or 4 PM. Lunch will be provided.
In order to get the most out of Morris's instruction and allow for a good amount of personal instruction, we are keeping the class size small. However, due to a couple of cancellations this week I can take two more. Maybe three. The cost for the seminar is just $35. Email to rodmaker@earthlink.net for specifics. ................... Re: Last Call
Posted by:
Les Stewart
(---.rh5.cm.dyn.comporium.net)
Date: April 24, 2012 09:35PM
I would love to be there, I tried to talk morris into doing something for my turning club, May the 5th is locked up and has been for months. Maybe next time. Re: Last Call
Posted by:
Larry Ohara
(---.clppva.east.verizon.net)
Date: April 25, 2012 10:40PM
Same here.
Tom, Not sure if this is feasible, and if Morris S. is willing. It would be nice to do something similair during the Expo. Maybe a day, 1/2 day, 2hrs, early or after, or even during the show. I would be willing to pay him $35 or a bit more to get instruction. Since I am already at the show it would be easier to stay an extra day or come in early just for the instruction instead of making two trips down. Right now I'm tearing up a lot of wood (scraps) trying to make that perfect insert! Learning a lot, but I got a lot of questions too. Just a suggestion. thank you. larry Sorry, only registered users may post in this forum.
|