SPONSORS
2024 ICRBE EXPO |
Mud Hole Bubble Blaster
Posted by:
mark kniss
(---.hsd1.ma.comcast.net)
Date: April 17, 2012 06:50AM
Does anyone have any experience using Mud Hole's Bubble Blaster? Re: Mud Hole Bubble Blaster
Posted by:
Bill Eshelman
(---.skylan.net)
Date: April 17, 2012 07:17AM
I use it on every epoxy job. Needless to say, I like it.
Bill Ohio Rod Builders Canton, Ohio Re: Mud Hole Bubble Blaster
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: April 17, 2012 11:38AM
works great. I use it often, almost on every job, especially on butt wraps. Caution is needed as too much can cause problems but it's a great tool if used properly.
Terry Re: Mud Hole Bubble Blaster
Posted by:
Glenn McMurrian
(---.hfc.comcastbusiness.net)
Date: April 17, 2012 01:53PM
Are you talking about the Bubble Buster in the spray bottle or the Bubble Buster that one uses to flame the epoxy as there are two different products Re: Mud Hole Bubble Blaster
Posted by:
Steve Mcleod
(---.64.244.87.dyn.jtglobal.com)
Date: April 17, 2012 05:30PM
Think they're refering to the mudhole bubble buster spray. Never tried it myself, i use the alcohol torch with the little spout that shoots a flame when you squeeze the bottle. Re: Mud Hole Bubble Blaster
Posted by:
mark kniss
(---.hsd1.ma.comcast.net)
Date: April 18, 2012 07:29AM
I'm refering to the spray bottle, the flame works ok, but one must be very careful as not to over heat the epoxy, this creates even more bubbles and also makes the finish run. It doesn't take much heat to make all of that happen. I ordered a bottle from Mud Hole, I'll give it a try. Thanks for your opinions. Sorry, only registered users may post in this forum.
|