SPONSORS
2024 ICRBE EXPO |
Cp & epoxy coverage
Posted by:
Soc Demos
(---.wdcz2.ken.bigpond.net.au)
Date: March 17, 2012 07:57PM
Hi everyone,
I have applied cp (chromaseal) to underbindings, however, I did mange to get a small amount onto the blank just past the trim ends. Will epoxy finish (threadmaster) cover the cp line where it meets the blank (has dried white in areas) so as the cp can not be seen, or do I need to carefully remove the dried cp from the trim line before applying epoxy finish? Thanking you. Re: Cp & epoxy coverage
Posted by:
Tom Kirkman
(Moderator)
Date: March 17, 2012 08:14PM
It shouldn't dry white - it should dry clear.
............ Re: Cp & epoxy coverage
Posted by:
Soc Demos
(101.119.15.---)
Date: March 17, 2012 09:52PM
Hi Tom,
I placed masking tape around the blank next to the trim when I coated with cp to keep it tidy. When I removed the masking tape after application, it gave a faint white mark in some areas. The wraps themselves dried clear, it's only a faint white edge in some areas where I removed the tape. Re: Cp & epoxy coverage
Posted by:
Col Chaseling
(---.lnse2.cht.bigpond.net.au)
Date: March 17, 2012 10:03PM
Hi Soc,
Some isoprophyl on a tissue will clean off cp if you manage to get it on the blank during application. Will also get it off when dry but it will take a bit of rubbing. ESFNEM Col Port Kembla, NSW Australia Re: Cp & epoxy coverage
Posted by:
Soc Demos
(---.wdcz2.ken.bigpond.net.au)
Date: March 17, 2012 11:03PM
Thanks Col. Sorry, only registered users may post in this forum.
|