SPONSORS
2024 ICRBE EXPO |
First EVA handle
Posted by:
Jim Scott
(---.tampfl.dsl-w.verizon.net)
Date: January 28, 2012 08:52PM
Good Evening Everyone,
Just finished stripping old 7' f/glass spinning rod. getting ready to order grips. i have only used cork previously and will be using EVA on this build. The butt diameter is about 5/8'' and the blank diameter at 16'' up from butt is 9/16''. Should i order 3/8'' bore eva or 1/2'' bore. I know it stretches and can be reamed just want to make the job easier. Thanks for the advise. Jim Scott Re: First EVA handle
Posted by:
Clyde Thomas
(---.bltmmd.fios.verizon.net)
Date: January 28, 2012 10:17PM
Jim,
1/2" i/d will work fine... make sure you prep the area with a scotchpad before applying the cement. You shouldn't need to ream anything, the new grip oughta slide right into place. Clyde Sorry, only registered users may post in this forum.
|