SPONSORS
2024 ICRBE EXPO |
80/20 Rod Wrapper
Posted by:
Mike Tilbury
(---.hsd1.mi.comcast.net)
Date: December 31, 2011 01:28PM
A couple years ago I noticed a wrapper in some photos that was built out of 80/20 aluminum extrusion. Does anyone have or know of someone who may have built one of these wrappers?
Mike Re: 80/20 Rod Wrapper
Posted by:
Doug Cox
(74.206.84.---)
Date: December 31, 2011 02:23PM
Click on the Photo link above - go to the equipment section. You will find several lathes that use the 80/20 for a base. Re: 80/20 Rod Wrapper
Posted by:
Tom Kirkman
(Moderator)
Date: December 31, 2011 03:00PM
There was a gentleman that made a few for Bob McKamey at Custom Tackle Supply. I seem to recall he may have passed away.
Doug Cox built a very nice home made unit from that material a few years back. His photos should be on the photo page here. .............. Re: 80/20 Rod Wrapper
Posted by:
Barry Thomas Sr
(---.hsd1.nj.comcast.net)
Date: December 31, 2011 05:31PM
I built mine from 8020 Extrusions.
if you have any Questions just e mail me Edited 1 time(s). Last edit at 12/31/2011 05:34PM by Barry Thomas Sr. Sorry, only registered users may post in this forum.
|