SPONSORS
2024 ICRBE EXPO |
Fuji ACS Trigger Reel Seats
Posted by:
Arthur Long
(---.dsl.hstntx.sbcglobal.net)
Date: August 22, 2011 07:26PM
I've been looking at the new generation of Fuji reel seats and my question is this. Is there a certain technique to applying the adhesive to the rod, since these are arbor-less designs? Or do I use the same method as though I'm using arbors? Any insight on this matter is greatly appreciated. Spend some, save some, give some away!!! :-) Re: Fuji ACS Trigger Reel Seats
Posted by:
Duane Richards
(---.ronkva.east.verizon.net)
Date: August 22, 2011 08:18PM
Same as with an arbor. Apply adhesive well above area and down to area where seat will sit. Slide seat into place, clean up access adhesive.
DR Re: Fuji ACS Trigger Reel Seats
Posted by:
Jeff Davis
(---.jax.bellsouth.net)
Date: August 23, 2011 12:30AM
make sure to clean the area where the blank show through. This will have to be done more than once, until the adhesive sets some. Usually 2 or 3 wipes with DNA will do, just keep an eye on it.
~Jeff~ ~~~~~~~~~~<(((>< Re: Fuji ACS Trigger Reel Seats
Posted by:
Arthur Long
(---.dsl.hstntx.sbcglobal.net)
Date: August 23, 2011 04:10PM
Thanks all I appreciate the input. Sorry, only registered users may post in this forum.
|