SPONSORS
2024 ICRBE EXPO |
microl sol?
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: August 07, 2011 10:36AM
I need to know what that Micro Sol does to the water slide decals after it put on the rod? Would I really need it? Thank you. Re: microl sol?
Posted by:
Rich Olson
(---.hsd1.fl.comcast.net)
Date: August 07, 2011 11:31AM
MIcro Sol is more intended for use on models, where the decal is to be placed over fine details that the modeler would
like to show through. It is basically a solvent that gellifies the decal so that it can flow around the details on the surface. You don't need it for applying waterslides to the smooth surface of a rod. There are a number of Decal setting solutions that some folks do like to use when applying waterslides. Use of these will make positioning the decal a bit easier, as well as give you a bit more time to work with, but, it is not a must. ~ RO Edited 1 time(s). Last edit at 08/07/2011 11:46AM by Rich Olson. Re: microl sol?
Posted by:
Duane Richards
(---.ronkva.east.verizon.net)
Date: August 07, 2011 11:41AM
No you do not need it.
DR Re: microl sol?
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: August 07, 2011 02:54PM
Thanks that will save me a few dollars, lol! Sorry, only registered users may post in this forum.
|