SPONSORS
2024 ICRBE EXPO |
Embedded spiral wrap
Posted by:
Bruce Tomaselli
(---.altnpa.east.verizon.net)
Date: August 02, 2011 07:24PM
Can someone recommend a tutorial on how to do a simple embedded spiral wrap? I used a search, but couldn't come up with any.
Bruce Edited 1 time(s). Last edit at 08/02/2011 07:26PM by Bruce Tomaselli. Re: Embedded spiral wrap
Posted by:
Tom Kirkman
(Moderator)
Date: August 02, 2011 07:43PM
Can you elaborate on what an "embedded spiral wrap" is?
............... Re: Embedded spiral wrap
Posted by:
Chuck Mills
(---.gctel.stellarllc.net)
Date: August 02, 2011 08:42PM
Do you mean a thread inlay with several bands to make it a spiral?
If so, try this... [www.rodbuilding.org] _________________________________________ "Angling is extremely time consuming. That's sort of the whole point." - Thomas McGuane Re: Embedded spiral wrap
Posted by:
Kurt Mogensen
(---.139.141.67.dynamic.ip.windstream.net)
Date: August 02, 2011 10:19PM
Here's a good one if you are looking for the spiral effect.
[www.rodbuildingtutorials.com] Re: Embedded spiral wrap
Posted by:
Bruce Tomaselli
(---.altnpa.east.verizon.net)
Date: August 02, 2011 10:55PM
Kurt Mogensen Wrote:
------------------------------------------------------- > Here's a good one if you are looking for the > spiral effect. > [www.rodbuildingtutorials.com] > orials/Embedded%20Thread%20Spiral.pdf Kurt's tutorial is what I'm looking to try. I guess to you guys this is very simple, but it's my first attempt. It doesn't look too complicated. I'm going to practice a bit and then give it a try. Thanks all for helping me. Bruce Re: Embedded spiral wrap
Posted by:
Raymond Adams
(---.hsd1.ca.comcast.net)
Date: August 03, 2011 09:27AM
The tutorial in the link Kurt posted is authored by Jeff Shafer Raymond Adams Eventually, all things merge, and a river runs through it.. Re: Embedded spiral wrap
Posted by:
Kurt Mogensen
(---.139.141.67.dynamic.ip.windstream.net)
Date: August 03, 2011 10:15AM
Raymond Adams Wrote:
------------------------------------------------------- > The tutorial in the link Kurt posted is authored > by Jeff Shafer Oh, yes. Absolutely correct. Not my tutorial. Just finishing off a rod on which I attempt the same thing so it was fresh in my mind where I had seen it. Its pretty easy and straight forward. Re: Embedded spiral wrap
Posted by:
Barry Thomas Sr
(---.hsd1.nj.comcast.net)
Date: August 03, 2011 07:11PM
just wrapped some myself
[www.rodbuilding.org] Edited 1 time(s). Last edit at 08/03/2011 07:12PM by Barry Thomas Sr. Re: Embedded spiral wrap
Posted by:
Bruce Tomaselli
(---.altnpa.east.verizon.net)
Date: August 03, 2011 07:22PM
Nice Barry. I did a few tonight myself and they didn't come out too bad. It made me feel like a "big shot pro" rod builder. HA! HA! Sorry, only registered users may post in this forum.
|