SPONSORS
2024 ICRBE EXPO |
Who makes a good metallic D thread?
Posted by:
kevin gross
(---.static.izoom.net)
Date: June 26, 2011 04:03PM
I tried Pro Wrap and though i love their thread their mtallic was so twisted it was VERY hard to work with. It was just a snarled mess as it came off of the spool. Any help would be appreciated! Kevin Gross Many men will spend their whole life wondering if they made a difference. Marines dont have that problem - Ronald Regan Re: Who makes a good metallic D thread?
Posted by:
Robbie Smith
(---.carolina.res.rr.com)
Date: June 26, 2011 04:30PM
Check out FishHawk Metallic P in "D". Re: Who makes a good metallic D thread?
Posted by:
Joe Willsen
(---.isp.broadviewnet.net)
Date: June 28, 2011 12:11PM
I had similar problems until I put the spool under tension instead of putting the thread through a tensioner. The thread backed up on itself a lot and came off the spool. Now all I do is have a piece of tape ready to put on the spool when I cut it so I don't get a backlash. Sorry, only registered users may post in this forum.
|