SPONSORS
2024 ICRBE EXPO |
Harrington 9' one piece.....
Posted by:
Wes Christy
(---.rh1.dyn.cm.comporium.net)
Date: May 12, 2011 08:47AM
A cutomer of mine has two older Harrington Blanks, Both 9' one piece, and he would like to basically recreate this blank since it no longer made. He wants two more rods, cost not an opiton, that match as closely as possible to the action and length of the Harrington blanks. Any help is greatly appreciated. Re: Harrington 9' one piece.....
Posted by:
John Britt
(---.tampabay.res.rr.com)
Date: May 12, 2011 10:33AM
Wes are you referring to the 540 series ,Lamiglas was making some Tarpon blanks that were close, not sure if they are still available
John Re: Harrington 9' one piece.....
Posted by:
Ken Preston
(---.bltmmd.fios.verizon.net)
Date: May 12, 2011 10:42AM
Maybe Lamiglas MB108-3M-B . Give Todd at Mudhole a call he should be able to steer you to a blank Re: Harrington 9' one piece.....
Posted by:
John Britt
(---.tampabay.res.rr.com)
Date: May 12, 2011 11:25AM
Wess if he has a 532 the lami MB1083M is close very nice blank as Ken said not quite the same though the Harringtons had much thicker walls
the SB 121 3M at 10" with some trimming might be closer to the 542 much depends on what he has again as Ken said check with Todd at Mudhole Re: Harrington 9' one piece.....
Posted by:
Chad Huderle
(---.static.twtelecom.net)
Date: May 12, 2011 11:53AM
Wes, if it were me I'd get a hold of one of the older Harrington blanks and measure the action angle and ERN. Maybe someone here can provide a 9' blank with similar properties. Thanks, Chad Huderle Huderle Custom Rods Prior Lake, MN Sorry, only registered users may post in this forum.
|