SPONSORS
2024 ICRBE EXPO |
Help needed: standing height of Fuji Alconite BYAG guides
Posted by:
Joe Fry
(---.hsd1.co.comcast.net)
Date: March 10, 2011 08:51AM
I would like to know the standing height of Fuji BYAG Alconite spinning guides, preferably in mm, from the rod surface to the top of the guide for the following guides: 25, 20, 16, 12, 10, 8, 7, 6. Can anyone help me? Using the NGC method this info will help me determine which guides I need to order.
Thanks much, Joe Re: Help needed: standing height of Fuji Alconite BYAG guides
Posted by:
Bill Napier
(---.hosted.static.webnx.com)
Date: March 10, 2011 09:07AM
25=52mm
20=44mm 16=33mm 12=27mm 10=22mm 8=17 I hope this is close enough. I will not promise it to be 100% exact but should be within a mm. I had to eyeball some I had on a rod against a ruler. Re: Help needed: standing height of Fuji Alconite BYAG guides
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: March 10, 2011 09:25AM
After you figure out what you need Start to get some extra guides maybe aluminum oxide high frame This way you can build a stash and have them to do tests with.
If you use Alconites all the time buy 1 or 2 extra and build a stash with those. Bill - willierods.com Re: Help needed: standing height of Fuji Alconite BYAG guides
Posted by:
Joe Fry
(---.hsd1.co.comcast.net)
Date: March 10, 2011 08:18PM
thanks a lot for the measurements. this should be close enough for me to be able to figure out what I need to order.
Joe Sorry, only registered users may post in this forum.
|